Welcome to the official website of Suzhou Hazardtex Mechanical Equipment Co., LTD!

Tel:013771823229／0512 69570129

语言切换

Language
- 中文版
- English

NEWS

Home page

Atex forklift introduction: What should the forklift pay attention to when starting and driving?

Release time:

2021-08-18

Source:

[Summary Description] Before driving, the driver should inspect and clean the site and passages to make them suitable for forklift operations and driving.

Do you know what you need to pay attention to when starting and driving the forklift? Let's follow the editor of Atex forklift to have a simple understanding!
1. Before driving, the driver should inspect and clean the site and passage to make it suitable for forklift operation and driving.
2. When starting, you should first close the emergency switch to open the electric lock, then turn the position of the direction switch, sound the horn, then start slowly and gradually accelerate, and it is forbidden to quickly depress the speed control pedal to start to prevent the starting current from being too large and burning Bad motor.
3. When driving, speed up gradually, and long-term low-speed driving is not allowed.

4. It is strictly forbidden to turn the direction switch while driving, only after the car has stopped. Only by flipping the direction switch can the direction switch be reversed. Sudden braking should be avoided as much as possible. In an emergency, you should quickly pull down the knife switch, step on the brake pedal, and stop immediately.
5. Honk the horn when starting and turning, and when turning, going downhill, uneven roads or passing through narrow passages, slow down and pay attention to safety.
6. When driving on the road, pass on the right side, the forklift should be about 100-200mm away from the ground, and the mast should be in the backward position. When two vehicles are driving in the same direction, the front and rear should be kept at a distance of more than 2m.
7. When multiple forklifts are driving on the platform, the distance between the front and rear should be more than 5m. When the same direction on a narrow platform, parallelism should be prohibited, and the distance from the edge of the platform should be more than 0.3m.
In summary, the editor of Atex forklift tells: a brief introduction to the matters needing attention in the starting and driving process of the forklift.