How much do you know about the maintenance knowledge of customized explosion-proof light? Let’s take a look at it briefly!
1. Maintenance personnel need to undergo on-the-job training to understand the performance of the lamps and clarify the requirements for use. Maintenance personnel must have professional knowledge and be familiar with the structure of lighting products.
2. Regularly eliminate the dust and dirt on the shell of the customized explosion-proof light, and improve the light efficiency and heat dissipation performance of the lamp. The cleaning method can be sprayed with water (above the shade of the sign on the lamp) or wiped with a damp cloth according to the protective ability of the lamp housing. When cleaning with water spray, the power supply should be cut off, and it is strictly forbidden to wipe the plastic shell (transparent part) of the lamp with a dry cloth to prevent static electricity.
3. Check the plastic shell (transparent part) of the lamp for serious discoloration. If the discoloration is serious, it indicates that the plastic has aged. Check whether the transparent parts have been impacted by foreign objects, whether the protective net is loose, desoldering, corrosion, etc. If so, stop using it and repair and replace it in time.
4. If the light source is damaged, turn off the light in time and notify the replacement to avoid long-term abnormal state of electrical components such as the ballast due to the failure of the light source to start.
5. If there is water in the lamp cavity of the lamp used in a humid environment, it should be removed in time, and the sealing part should be replaced to ensure the protective performance of the shell.
6. When opening the lampshade, you should open the cover after disconnecting the power supply according to the requirements of the warning sign.
7. After opening the cover, check whether the flameproof joint surface is intact, whether the rubber seal is hard or sticky, whether the wire insulation layer is green and carbonized, whether the insulation and electrical components are deformed and scorched. If these problems are found, they should be repaired and replaced in time.

8. The model, specification, size and performance of the light source, parts and electrical components after repair and replacement should be exactly the same as the light source, parts and electrical components before repair and replacement.
9. Before closing the cover, use a damp cloth (not too wet) to gently wipe the light return and transparent parts of the lamp to improve the light efficiency of the lamp. A thin layer of 204-1 replacement anti-rust oil should be applied to the flameproof joint surface. When closing the cover, pay attention to whether the sealing ring plays a sealing role in the original position.
10. The sealed part of the lamp should not be disassembled and opened frequently.
The above is an introduction to the maintenance knowledge of customized explosion-proof light.